The subdivider shall submit the preliminary plat drawn to a scale of fifty feet to one inch, or one hundred feet to one inch. The required number of copies of the plat shall be specified by the staff. However, if the resulting drawing would be over thirty-six inches in the shortest dimensions, a smaller scale may be used, if approved by the commission. The preliminary plat shall show:

    A.    Proposed name of subdivision (which shall be subject to commission review);

    B.    Location by township, range and section, or by other legal description;

    C.    Name and address of subdivider;

    D.    Name and address of surveyor;

    E.    Scale, north point and date;

    F.    Boundary line of subdivision;

    G.    Boundary lines of adjacent tracts showing ownership;

    H.    Existing zoning of proposed subdivision and adjacent tracts;

    I.    Topographic contours at vertical intervals of two feet if the general slope of the site and adjacent roadways is less than ten percent. Topographic contours at vertical intervals of five feet will be permitted where the general slope is greater or equal to ten percent.

    J.    All existing permanent fixtures either natural or manmade that may influence the design of the subdivision, such as: water courses, regulated drains, tree groves, swamps, outstanding natural topographic features, power transmission towers, scenic or historic areas, existing buildings, sewers, water mains, storm sewers, dry wells, utility lines and fire hydrants. The location and pipe size of any water mains, sanitary sewers, storm sewers and natural gas mains that exist on the site shall be noted in their approximate location. The direction of the flow shall be noted for sanitary sewers and storm sewers;

    K.    Locations, dimensions and names of all existing or prior platted streets or other public ways, railroad and utility rights-of-way, parks and other public open spaces, permanent buildings and structures, and section and municipal corporation lines, within and adjoining the proposed plat;

    L.    The scalar layout of all proposed and existing lots with appropriate dimensions and the minimum area in square feet for each lot and proposed front yard setback lines;

    M.    Layout of all proposed streets, widths of right-of-way, and the widths of cross walkways and easements;

    N.    Parcels of land intended to be dedicated or temporarily reserved for public use or set aside for use of property owners in the subdivision;

    O.    The proposed location, size and grade of all sanitary sewers and the location of all manholes and service connections;

    P.    The proposed location and size of all water mains and the location of all fire hydrants and valves;

    Q.    Typical street cross-sections for each proposed street width in the subdivision;

    R.    Plan commission certificate. (Ord. 99-24 § 3 (part), 1999: Ord. 98-10 § 3 (part), 1998; prior code § 28-20)